Skip to product information
200G Sample Filament Spool 1.75mm
$9.90
Reliable shipping
Flexible returns
I. Usage Instructions
1. Opening & Storage
- Seal the filament immediately after opening.
- Store in a sealed bag with desiccant when not in use for extended periods.
- Avoid high temperature and high humidity environments.
Moisture may cause:
- Increased stringing
- Unstable extrusion
- Surface bubbles
- Rough surface finish
- Poor layer adhesion
2. Pre-print Check
- Confirm nozzle is clear with no clogs.
- Keep the print platform clean.
- Select print parameters based on material type.
- Run a first-layer test before starting the full print.
3. Platform Adhesion Tips
| Platform Type | Recommendation |
|---|---|
| PEI Steel Sheet | Usually no adhesive needed; apply glue if necessary |
| Glass Bed | Recommended to use solid glue for better adhesion |
| Other Platforms | Adjust based on actual print results |
4. Common Issue Troubleshooting
| Issue | Suggested Fix |
|---|---|
| Stringing | Lower nozzle temp; increase retraction |
| Clogging | Check for moisture; reduce print speed |
| Warping | Increase bed temp; improve enclosure |
| Rough surface | Check drying status and temperature |
| Poor layer bonding |
Increase nozzle temperature |
Notes:
- Can be printed at room temperature; avoid cold drafts.
- Seal after opening; moisture causes stringing, bubbles, rough surface.
- If adhesion is poor, clean the platform first, then apply a small amount of adhesive.